Application Guideline:

A] Surface Preparation

1. Surface must be free from dust, oils, grease, and loose particles. Moisten the surface before applying Prof. Seal – CrackPlug.
2. Fine hair line cracks must be widened up to 1 mm minimum using scrapper and then filled
3. For filling Professor Seal – CrackPlug on the internal surface, existing POP or painter’s putty must be removed till plaster surface is exposed.
4. For porous surfaces, apply primer coat prepared with Prof. Seal – CrackPlug and water in 1:1 proportion over the crack.
5. Fill Professor Seal – CrackPlug when the surface is tacky and not dried completely.

B] Application:

1. Work Professor Seal – CrackPlug firmly into the crack with spatula or putty knifes and level smooth with surface.
2. Care must be taken to avoid voids or bubbles during application process.
3. Allow it set for 24 hours and then apply another coat of Prof. Seal – CrackPlug.
4. Further finishes may be applied once it is fully dry.
5. For better results allow Prof. Seal – CrackPlug to cure for 7 days after final coat application.

C] Precautions:

1. Should not be used for cracks more than 5 mm wide.
2. Not for application in cracks in structural members, expansion joints & separation gaps.
3. Not for cracks in gypsum plaster or painter’s putty.
4. For application below 100C, drying time will be delayed.